3. Set the values of the parameters that you want to provision.
4. Save the Settings file.
Result
On the next poll, the phones download the Settings file and apply the configuration settings.
Related links
File Server configuration on page 97
List of configuration parameters on page 194
DHCP server configuration
You can configure the DHCP server to:
• Dynamically assign IP addresses to Avaya J100 Series IP Phones.
• Provision phone and site-specific configuration parameters through various DHCP options.
In a Device Enrollment Services (DES) environment, the DHCP server is primarily used to assign
IP addresses to the phones. The phones receives the file server address from the DES server.
Related links
Server configuration on page 97
Setting up a DHCP server on page 104
Setting up a DHCP server
About this task
Use this procedure to set up a third-party DHCP server.
Before you begin
Contact your server software vendor to obtain server software installation and configuration
instructions.
Procedure
1. Install the DHCP server software according to the software vendor’s instructions.
2. Create a DHCP scope to define the range of IP addresses for the phones.
3. Configure the required DHCP options.
The DHCP site-specific option that you configure must match the Site Specific Option
Number (SSON) that the phones use. The default SSON that the phones use is 242.
Related links
DHCP server configuration on page 104
Configuring servers and VLAN
December 2018 Installing and Administering Avaya J100 Series IP Phones 104
Comments on this document? infodev@avaya.com
To Next Page
Loading...
Need help?
General
