Chapter 3: Phone installation
Hardware setup
Wi-Fi overview
The Wi-Fi module enables the phone to connect to a network through a wireless network. If the
phone loses connection to one Wi-Fi network, it continues to operate with another redundantly
configured wireless network or Ethernet network. A Wi-Fi status icon displays when Wi-Fi is in
use. If the phone is connected to Ethernet switch and the Ethernet link goes down, a pop-up
message displays to change network connectivity to Wi-Fi.
You can configure Wi-Fi network by:
• Setting Wi-Fi parameters by using the 46xxsettings.txt file
• Configuring Wi-Fi from the phone UI
• Configuring Wi-Fi parameters from the web UI
Note:
VLAN and LLDP functionalities are not supported over a wireless network.
J100 wireless module
Avaya J129 IP Phone and Avaya J179 IP Phone support wireless module. The wireless module is
an optional component and you can order this module separately.
Note:
Avaya J139 IP Phone and Avaya J169 IP Phone do not support J100 wireless module.
Installing the wireless module
Before you begin
Obtain the following items:
• Phillips #1 screw driver to install the screw of the J100 Wireless Module.
• A flat screw driver that fits in the opening of the module panel.
December 2018 Installing and Administering Avaya J100 Series IP Phones 21
Comments on this document? infodev@avaya.com
To Next Page
Loading...
Need help?
General
