Name Description
The options are:
• Enable
• Disable (default)
UDP Port for discovery and
test messages
Specifies the port used to receive packets from an SLA Monitor server.
Valid value is an integer from 6000 to 65535. The default value is
50011.
Other
Serial Port Specifies if the port for network traffic is enabled or disabled.
The options are:
• Enable
• Disable (default)
Related links
Debugging on page 84
Configuring certificates
About this task
Avaya J100 Series IP Phones display the details of the configuration fields in the Description
section.
Procedure
1. Log in to the web interface as an administrator.
2. In the navigation pane, click Certificates.
3. Configure the following areas:
• Certificates
• Online Certificates Status Protocol (OCSP)
• SCEP
• PKCS12
• Web Server
4. Click one of the following:
• Save: To save the configuration changes.
• Reset to Default: To revert to the default values.
Related links
Certificates field descriptions on page 89
Configuring the phone using web interface
December 2018 Installing and Administering Avaya J100 Series IP Phones 88
Comments on this document? infodev@avaya.com
To Next Page
Loading...
Need help?
General
