Procedure
1. In your browser, enter the IP address of the phone, and press Enter.
2. On the Login page, enter the username and the password in the corresponding fields.
For more information about changing the default password, see
Logging in and logging out
of the web interface on page 43.
3. Navigate to Ethernet > IPv4 Configuration.
4. Configure IPv4 addresses in the following way:
• To enable DHCPv4, select Yes from the drop-down menu next to the Use DHCP option.
• Enter the required values in IPv4 Address, Subnet Mask and IPv4 Gateway fields.
5. Scroll to the end of the Ethernet page, and press Save.
IPv6 configuration
Use the 46xxsettings.txt file to set the following parameters for IPv6 operation:
Parameter name Default value Description
DHCPSTDV6 0 Specifies whether DHCPv6 will
comply with the IETF RFC 3155
standard and immediately stop
using an IPv6 address if the
address valid lifetime expires, or
whether it will enter an extended
rebinding state.
Value operation:
• 0: DHCPv6 enters proprietary
extended rebinding state
(continue to use IPv6 address,
if DHCPv6 lease expires).
• 1: DHCPv6 complies with IETF
RFC 3155 standard
(immediately release IPv6
address, if DHCPv6 lease
expires).
DUAL_IPPREF 4 DUAL_IPPREF controls the
following:
• The selection of SSON either
from DHCPv4 or DHCPv6
server, when phone is in dual
mode, and
Table continues…
Configuring servers and VLAN
December 2018 Installing and Administering Avaya J100 Series IP Phones 124
Comments on this document? infodev@avaya.com
To Next Page
Loading...
Need help?
General
