Name Description
Signaling DiffServ (Layer 3) Specifies the layer 3 Differentiated Services (DiffServ) code point for
signaling frames generated by the phone.
The valid value is an integer from 0 to 63. The default value is 34.
LLDP
LLDP Specifies the status of LLDP.
The options are:
• Disabled
• Enabled
• Enabled- only if LLDP frame is received (default)
Ethernet Interface
Ethernet Specifies the speed and duplex settings for the Ethernet line interface.
The options are:
• Auto-negotiate (default)
• 10Mbps half-duplex
• 10Mbps full-duplex
• 100Mbps half-duplex
• 100Mbps full-duplex
PC Ethernet Specifies the speed and duplex settings for the secondary (PC)
Ethernet interface.
The options are:
• Disable
• Auto-negotiate (default)
• 10Mbps half-duplex
• 10Mbps full-duplex
• 100Mbps half-duplex
• 100Mbps full-duplex
PC Ethernet auto-MDIX Specifies the status of the auto-MDIX on PHY2.
The options are:
• Enable (default)
• Disable
Related links
Configuring Ethernet settings on page 46
Configuring Ethernet settings
December 2018 Installing and Administering Avaya J100 Series IP Phones 51
Comments on this document? infodev@avaya.com
To Next Page
Loading...
Need help?
General
