Appendix
AX3000 Models 80 and 85 - User's Manual 199
All these general parameters are located in sub-menus from [Configuration]-[Advanced]-
[Tuning]:
a) Network Menu
DNS Cache: this option allows the thin client to maintain a DNS cache.
IP Address Set by Ping: this parameter allows or disables the AX3000 IP Address to be set by a
ping command. (See Appendix A.7.6.)
Allow Network Discover: by default, SNMP requests are supported by Axel thin clients. This
allows thin clients to be discovered by AxRM (the Axel administration software). This parameter
can be used to disabled the SNMP support.
MTU: set the Maximum Transfer Unit value (Ethernet layer).
TCP SACK Enabled: this is an optimization to improve performance in the event of TCP packet
loss (see RFC 2883).
Wireless PSK/EAP version: see Chapter 3.1.3 section d).
Show Connection Messages: turn on/off verbose mode when a connection is established.
Net Tracer: turn on/off network trace messages.
DNS Trace Mode: turn on/off DNS trace messages.
DHCP Trace Mode: turn on/off DHCP trace messages.