Installing under OS/400
124 AX3000 Models 80 and 85 - User's Manual
- Username: predefined user name
- Password: available only if 'Username' is not empty.
- Program/Procedure: available only if 'Username' is not empty.
- Menu: available only if 'Username' is not empty.
- Current Library: available only if 'Username' is not empty.
Important: the auto-signon function must be allowed at the OS/400 level. To enable it set the
QRMTSIGN variable to *VERIFY (command CFGTCP).
6.1.6 - Connection Properties
The following box is displayed:
These parameters are:
- TERM Value: terminal capabilities. Default value is IBM-3477-FC.
- Auto-Connection: if this parameter is set to 'yes', the connection will be automatically
established when the AX3000 is powered. Otherwise, the user can press <Alt><Fx> to
establish the connection.
- Auto-Reconnection: if this parameter is set to 'yes', a new connection is automatically
established after a disconnection. Otherwise, the user can press <Alt><Fx> to establish a
new connection.
- Session Label: this character string (11 characters max.) is used to identify the session
within the local desktop or in the taskbar.
- Enhanced Parameters: see Appendix A.7.3.
6.2 - USING THE AX3000
6.2.1 - The 5250 Status Line
Note: the 5250 status line is different than the AX3000 TCP/IP status line. (The AX3000 TCP/IP
status line displays information about current connected sessions. This line can be
enabled/disabled through the AX3000 Set-Up).
The 5250 status line is displayed at the bottom of the screen and gives the following information:
System Available Upper Shift
Message(s) Waiting Caps Lock Function key Assignment
Input Inhibit Insert
X A ^ ð R 63 LL/CC