Interactive Set-Up
AX3000 Models 80 and 85 - User's Manual 65
3.6 - OTHER FUNCTIONS
Less-used functions are available through the [Configuration]-[Advanced] menu:
3.6.1 - Tuning
This box offers special thin client operating parameters. Usually the default values are suitable.
For more information see Appendix A.7.2.
3.6.2 - Auto-Configuration
The Auto-Configuration function lets a thin client check if new firmware and/or new configuration
files are available.
This function is automatically started when the thin client is powered-on for the very first time. See
Chapter 2.2.
Additionally this function can also be set to run each time the thin client boots:
The 'time-out' parameter is the maximum number of seconds allowed for the thin client to load a
new firmware/configuration. If nothing is received in this time the thin client boots up using existing
current settings.
Two methods are available for the thin client to locate the AxRM server (IP address and TCP port):
- Static: the IP address (or the name) and the TCP port are entered
- Dynamic (only if DHCP is already used to get the thin client IP address): the IP address and
TCP port are given through the DHCP protocol (see Chapter 2.2.3 for more information).
For more information about Auto-Configuration stages, refer to Chapter 2.2.