Barco RLM series - VCO, Increment; VCO, Decrement

3. Advanced Commands
Command [0]
\x26
Command [1]
\x5d
maximum active pixels
Command [0]
\x27
Command [1]
\x5d
minimum pixel start
Command [0]
\x26
Command [1]
\x5e
maximum pixel start
Command [0]
\x27
Command [1]
\x5e
minimum clamp width
Command [0]
\x26
Command [1]
\x68
maximum clamp width
Command [0]
\x27
Command [1]
\x68
3.31.10 VCO, Increment
VCO
The Voltage Controlled Oscillator is used in a Phase Locked Loop which allows to synchronise the data pocessing
with the incoming source data.
Description
Increments the VCO by one
Command
Command [0]
\x22
Command [1]
\xa8
3.31.11 VCO, decrement
VCO
The Voltage Controlled Oscillator is used in a Phase Locked Loop which allows to synchronise the data pocessing
with the incoming source data.
Description
Decrements the VCO by one.
R5976884 RLM SERIES 04/04/2006
149