Barco RLM series - Vco,Write; VCO, Read

3. Advanced Commands
Command
Command [0]
\x23
Command [1]
\xa8
3.31.12 VCO,write
Description
Writes a new VCO value to the projector
Command
Command [0]
\x20
Command [1]
\xa8
Data
Data [0] = VCO value
Data[0] = unsigned byte
The range can be found with the “read max/min” commands:
range min: "Minimum VCO, Read", page 151
range max :"Maximum VCO, Read", pag e 151
3.31.13 VCO, Read
Description
Reads the actual VCO value of the projector
Command
Command [0]
\x21
Command [1]
\xa8
Returned Data
Data [0] = VCO value
data type = unsigned byte
Example
Reads the actual VCO value , the awnser being \x00
Transmit
Start
\xfe
Projector address
\x01
Command[0]
\x21
Command[1]
\xa8
Checksum
\xca
Stop
\xff
150 R5976884 RLM SERIES 04/04/2006