Barco RLM series - Source Selection

2. Basic Commands
Receive (acknowledge)
Start
\xfe
Projector address
\x01
Command[0]
\x00
Command[1]
\x06
Checksum
\x07
Stop
\xff
2.9 Source selection
Description
Selects an input source.
Command
Command [0]
\x38
Data
Data[0] = bySource, byte describing the source to be linked to the window.
Byte value
source
1
BNC’s
2 D15
3
Composite video
4
SVideo
5
DVI
6 Firewire
7
SDI
8
IQ PC
For more info about the input configurations, see the projector’s Owner’s manual.
Data[1] = byMode
for BNC’s and D15: the data byte gives the type of signal present on the BNC’s/D15
Byte value Mode
0
RGBHV
1
RGBCS (analog
4
)
2
RGBCS (digital)
3
RG
s
B
100 (x\64)
PrYPb
101(x\65)
RGB video
102(x\66)
RG
S
B video
4. the signal present on the Cs signal is a composite video signal containing the composite sync
46 R5976884 RLM SERIES 04/04/2006