Barco RLM series - Lamp Status, Read

2. Basic Commands
Receive (acknowledge)
Command[0]
\x00
Command[1]
\x06
Checksum
\x07
Stop
\xff
Receive (Answer)
Start
\xfe
Projector address
\x01
Command[0]
\x21
Command[1]
\x0c
Data [0]
\x00
Checksum
\x2e
Stop
\xff
2.30.3 Lamp Status, Read
Description
Reads the actual Lamp Status of the projector
Command
Command [0]
\x21
Command [1]
\x0d
Returned Data
Data [0] = Lamp Mode = unsigned byte see "Lamp Mode, Read", page 63
Data [1] = Active lamp(s) = unsigned byte (see following table)
Lamp
byte Hex
Lamp1 0001
\x01
Lamp2 0010
\x02
Lamp1+Lamp2 0011
\x03
Table 2-209
Lamp status: active lamps table
Example
Reads the actual Lamp Status of the projector, the awnser being \x01 = Lamp1 (in single mode)
Transmit
Start
\xfe
Projector address
\x01
Command[0]
\x21
Command[1]
\x0d
Checksum
\x2f
Stop
\xff
64 R5976884 RLM SERIES 04/04/2006