Warnings 13
2 Warnings
2.1 General Warnings
READ AND UNDERSTAND THIS MANUAL BEFORE APPLYING POWER TO THE PL/X DRIVE UNIT
The PL/X motor drive controller is an open chassis component for use in a suitable enclosure
Drives and process control systems are a very important part of creating better quality and value in the goods
for our society, but they must be designed, installed and used with great care to ensure everyone's SA FETY.
Remember that the equipment you will be using incorporates...
High voltage electrical equipment
Po werful rotating machinery with large stored energy
Heavy components
Your process may involve...
Hazardous materials
Expensive equipment and facilities
Interactive components
Always use qualified personnel to design, construct and operate your systems and keep SAFETY as your
primary concern.
Thorough personnel training is an important aid to SAFETY and productivity.
SAFETY awareness not only reduces the risk of accidents and injuries in your plant, but also has a direct
impact on improving product quality and costs.
If you have any doubts about the SAFETY of your system or process, consult an expert immediately. Do not
proceed without doing so.
HEALTH AND SAFETY AT WORK
Electrical devices can constitute a safety hazard. It is the responsibility of the user to ensure the compliance
of the installation with any acts or byla ws in force. Only skilled personnel should install and maintain this
equipment after reading and understanding this instruction manual. If in doubt refer to the supplier.
Note. The contents of this manual are believed to be accurate at the time of printing. The manufacturers,
however, reserve the right to change the content and product specification without notice. No liability is
accepted for omissions or errors. No liability is accepted for the installation or fitness for purpose or
application of the PL/X motor drive unit.
D ANGER
ELECTRIC SHOC K RISK
To Next Page
Loading...