Bardac PLX - 5.2.7 Full menu diagram (Block OP and Fieldbus configs, Drive personality and Conflict Help)

Menu tree stucture 55
5.2.7 Full menu diagram (Block OP and Fieldbus configs, Drive personality and Conflict Help)
Continued from previous page…..
CONFLICT HELP MENU
Number of conflicts
Multiple G OTO on PIN
PASSIVE MOTOR SET
Rated armature amps
Current limit %
Rated field amps
Base rated RPM
Desired maximum RPM
Zero speed offset
Max tacho volts
Speed feedback type
Quadrature enable
Encoder lines
Motor/encoder speed ratio
Encoder sign
IR compensation
Field current feedback
trim
Armature volts trim
Analog tacho trim
Rated armature volts
Forw ard up time
Forw ard do wn time
Reverse up ti me
Reverse do wn time
Jog speed 1
Jog speed 2
Slack speed 1
Slack speed 2
Cra wl speed
Jog mode select
Jog/slack ramp
Stop ramp time
Drop-out speed
Internal speed reference 1
Speed reference 2
Speed/current ref 3 mon
Ramped speed reference
4
Speed/current reference 3
si gn
Speed/current reference 3
ratio
Maximum positive speed
reference
Maximum negative speed
reference
Speed proportional gain
Speed integral time
constant
Current clamp scaler
Current proportional gain
Current integral gain
Current discontinuity
4 Quadrant mode
Field enable
Field volts output
Standstill enable
Zero interlock speed %
Zero interlock current %
BLOCK OP CONFIG
Run mode ramps goto
Motorised pot goto
Reference exch slave goto
Application block GO TO
connections.
DRIVE PERSONALITY
Passive motor set
Recipe page
Max current response
ID monitor (Unit Identity)
Armature current burden
ohms
Bl ock output config
Fieldbus Config
Drive personality
Conflict help menu
Configuration
Parameter save
FIELDBUS CONFIG
Jumper 1 to 8 GETFROM
Bit-Packed GETFRO M
Jumper 9 to 16 G OTO
Bit-Packed GO TO
Fieldbus data control
Bit-Packed GETFROM
Jumper 1 to 8 GETFROM
Bit-Packed GOTO
Jumper 1 to 8 G OTO