Bardac PLX - 5.2.1 Full menu diagram (Change parameters)

Menu tree stucture 49
5.2.1 Full menu diagram (Change parameters)
CHANGE PARAMETERS
Section 6
Run mode ramps
Jog craw l slack
Motorised pot ramp
Stop mode ramp
Speed reference summer
Speed control
ENTRY MENU
Section 5
Change parameters
JOG CRAWL SLACK
Jog speed 1
Jog speed 2
Slack speed 1
Slack speed 2
Cra wl speed
Jog mode select
Jog/slack ramp
RUN MODE RAMPS
Ramp output monitor
Forw ard up time
Forw ard do wn time
Reverse up ti me
Reverse do wn time
Ramp input
Forw ard minimum speed
Reverse minimum speed
Ramp auto preset
Ramp external preset
Ramp preset value
Ramp S-profile %
Ramp hold
Ramping threshold
Ramping flag
MOTORISED POT RAMP
Output monitor
Up time
Do wn time
Up command
Do wn command
Maximum clamp
Minimum clamp
Preset
Preset value
Memory boot up
STOP MODE RAMP
Stop ramp time
Stop time limit
Live delay mode
Drop-out speed
SPEED REFERENCE
SUMMER
Internal speed reference 1
Speed reference 2
Speed/current ref 3 mon
Ramped speed reference 4
Speed/current reference 3
si gn
Speed/current reference 3
ratio
Continued on next page…..
SPEED CONTROL
Maximum positive speed
reference
Maximum negative speed
reference
Speed proportional gain
Speed integral time
constant
Speed integral reset
Speed PI adaption
SPEED PI ADAPTION
Low breakpoint
High breakpoint
Low breakpoint
proportional gain
Low breakpoint integral
time constant
Integral % during ramp
Speed adaption enable