Warnings 15
2.3 General Risks
INSTALLATION: THIS PRODUCT IS CLASSIFIED AS A COMPONENT AND MUST BE USED IN A
SUITABLE ENCLOSURE
Ensure that mechanically secure fixings are used as recommended.
Ensure that cooling airflow around the product is as recommended.
Ensure that cables and wire terminations are as recommended and clamped to
required torque.
Ensure that a competent person carries out the installation and commissioning of
this product.
Ensure that the product rating is not exceeded.
APPLICATION RISK: ELECTROMECHANICAL SAFETY IS THE RESPONSIBILITY OF THE USER
The integration of this product into other apparatus or systems is not the
responsibility of the manufacturer or distributor of the product.
The applicability, effectiveness or safety of operation of this equipment, or that of
other apparatus or systems is not the responsibility of the manufacturer or
distributor of the product.
Where appropriate the user should consider some aspects of the following risk assessment.
RISK ASSESSMENT: Under fault conditions or conditions not intended.
1. The motor speed may be incorrect. 2. The motor speed may be excessive.
3. The direction of rotation may be incorrect. 4. The motor may be energised.
In all situations the user should provide sufficient guarding and/or additional redundant monitoring and safety
systems to prevent risk of injury. NOTE: During a po wer loss event the product will commence a
sequenced shut down procedure and the system designer must provide suitable protection for this case.
MAINTENANCE: Maintenance and repair should only be performed by compete nt persons using only
the recommended spares (or return to factory for repair). Use of unapprove d parts may create a hazard and
risk of injury.
WHEN REPLACING A PRODUCT IT IS ESSENTIAL THAT ALL USER DEFINED
PARAMETERS THAT DEFINE THE PRODUCT'S OPERATION ARE CORRECTLY
INSTALLED BEFORE RETURNING TO USE. FAILURE TO DO SO MAY CREATE A
HAZAR D AND RISK OF INJURY.
PA CK A GING: The packaging is combustible and if disposed of incorrectly may lead
to the generation of toxic fumes, w hich are lethal.
WEIGHT: Consideration should be given to the w eight of the product when handling.
REPAIRS: Repair reports can only be given if the user makes sufficient and accurate defect reporting.
Remember that the product without the required precautions can represent an electrical hazard and risk of
injury, and that rotating machinery is a mechanical hazard.
PROTECTIVE INSULATION:
1. All exposed metal insulation is protected by basic insulation and user bonding to earth i.e. Class 1.
2. Earth bonding is the responsibility of the installer.
3. All signal terminals are protected by basic insulation, and the user earth bonding. (Class 1). The purpose
of this protection is to allo w safe connection to other lo w voltage equipment and is not designed to allo w
these terminals to be connected to any un-isolated potential.
To Next Page
Loading...