14 Warnings
2.2 Warnings and Instructions
WARNING
Only qualified personnel who thoroughly understand the operation of this
equipment and any associated machinery should install, start-up or attempt
maintenance of this equipment. Non compliance with this w arning may result in
personal injury and/or equipment damage. Never work on any control equipment
without first isolating all po wer supplies from the equipment. The drive and motor
must be connected to an appropriate safety earth. Failure to do so presents an
electrical shock hazard.
CAUTION
This equipment w as tested before it left our factory. However, before
installation and start-up, inspect all equipment for transit damage, loose
parts, packing materials etc. This product conforms to IPOO protection.
Due consideration should be given to environmental conditions of
installation for safe and reliable operation. Never perform high voltage
resistance checks on the wiring without first disconnecting the product
from the circuit being tested.
STATIC SENSITIVE
This equipment contains electrostatic discharge (ESD) sensitive
parts. Observe static control precautions when handling,
installing and servicing this product.
THESE WARNINGS AND INSTRUCTIONS ARE INCLUDED TO ENABLE THE USER TO OBTAIN
MAXIMUM EFFECTIVENESS AND TO ALERT THE USER TO SAFETY ISSUES
APPLICATION AREA: Industrial (non-consumer) " Motor speed control utilising DC motors " .
PRODUCT MANUAL: This manual is intended to provide a description of ho w the product works. It is not
intended to describe the apparatus into which the product is installed.
This manual is to be made available to all persons who are required to design an application, install, service
or come into direct contact with the product.
APPLICATIONS ADVICE: Applications advice and training is available from Sprint Electric.
Bardac.
To Next Page
Loading...