60
Startup and Basic Operation
Frequency Generation
The frequency generation terminals are located in the ET module.
Required settings Options/description
Quantity Freq.
Funct/Port ET: f(gen)
Also check the Unit and Waveform set-
tings.
MC5P generates sine or square wave with
given amplitude and frequency. Minimum
allowed frequency is 1 Hz, but the specifi-
cation is valid for frequencies above 40 Hz
only. When generating a square wave, the
output DC-level can be set to symmetric or
all positive.
The amplitude (V
pp
) setting range is: 0.01 V to 12 V.
Next…
Pulse Generation on page 61
Frequency Measurement on page 44
Special Generations on page 65
Calibration, see Part D.
ELECTRICAL MODULE
FOR MC5P
S/N
MULTIFUNCTION CALIBRATOR
MC5PE
?
ET
ELECTRICAL AND TEMPERATURE MODULE
FOR MC5P
S/N
Max 60 VDC/30 VAC
Max 60 VDC
Max 30 VAC
OUTPUT
SENSOR MEASURE & SIMULATE
INTERNAL REFERENCE JUNCTION
FOR THERMOCOUPLES
T/C, Low V
4-w meas
R, RTD
V, I,
3 & 4-w meas
Open
Close
Open
Close
T/C INT. RJ
T/C
WIRES
ONLY
(ENV), ENVIRONMENTAL
TEMPERATURE SENSOR
(EXT), EXTERNAL
PRESSURE MODULE
MEASURE
+24V
I
meas/sink
HART
®
2-w xmtr
V, ,
Low V
Com
To Next Page
Loading...
