Bobcat S850 - Operating with Loads on Slopes; Operating with Full Bucket on Slopes; Operating with Empty Bucket on Slopes

96 S850 Operation & Maintenance Manual
ATTACHMENTS (CONT’D)
Installing And Removing The Attachment (Power Bob-Tach) (Cont’d)
Removing (Cont’d)
3. Enter the loader and perform the PRE-STARTING
PROCEDURE. (See PRE-STARTING PROCEDURE
on Page 77.)
4. Start the engine, press the PRESS TO OPERATE
LOADER button and release the parking brake.
Figure 139
Figure 140
Push and
hold BOB-TACH “WEDGES UP” switch (Right
Switch Panel) [Figure 139] until levers (Item 1)
[Figure 140] are fully raised (wedges fully raised).
Figure 141
Tilt the Bob-Tach forward and drive the loader backward,
a
way from the bucket or attachment [Figure 141].
NOTE: The Power Bob-Tach system has continuous
pressurized hydraulic oil to keep the wedges
in the engaged position and prevent
attachment disengagement. Because the
wedges can slowly lower, the operator may
need to reactivate the switch (BOB-TACH
WEDGES UP) when removing an attachment
to be sure both wedges are fully raised.
P-85320A
P-85361A
1
P-31231
98 of 210
Dealer Copy -- Not for Resale