12-10îš¡ Working with the File Management Utility
Note: In order to create a cut out graphic (*.cog), you must open the graphic in a
graphic editor and save it as an *.ai file. Then, rename the file with the
*.cog extension in Explorer.
Installing the File Management Utility
To install the File Management Utility, complete the following steps:
1. Insert the GlobalMark 2 Utilities CD-ROM.
2. Select Install File Management Utility.
OR If Autorun is disabled, you can begin the installation process manually:
1. Insert the GlobalMark 2 Utilities CD-ROM.
2. Click on Start|Run
3. Type D:\File Management Utility\Setup.exe and click OK.
Note: Follow the InstallShield Wizard’s setup instructions until you have
finished the installation. (If an error occurs, please verify that you meet or
exceed the recommended system requirements.)
To Next Page
Loading...
Need help?
General
