Connecting to a PC îš¡12-5
2. Choose the online tab, shown here:
Figure 12-2. The online tab screen.
3. Choose a connection type. If your PC does not have a USB connector, choose
serial.
Note: You’ll also use the File Management Utility to upgrade the operating
system for your printer.
4. Choose OK. You’ll be returned to the Main Menu screen.
Connecting your system and a PC
In this procedure, you make the actual connection between the PC and your printer.
To place your label printing system online
1. Connect one end of the cable to your printing system and the other to a PC.
The cable you use, USB or serial, should be same as you used in the procedure
described in
Setting Up Your System as a Hardware Device on page 12-3.
2. Turn on your printing system.
To Next Page
Loading...
Need help?
General
