Setting Up îš¡ 2-3
Step 3: Plug the power cord into the printer as shown in Figure 2-1. Plug the other end of
the cord into an AC power outlet.
Important! Be sure the AC power outlet is located near the printer and is
easily accessible.
Installing supplies
The next step in setting up your printer is installing a ribbon cartridge and a tape
cartridge. Your system reads information stored in the memory cell located on each
ribbon and tape cartridge, and uses that information when you compose a label and
when you print a label.
Hint! Before composing a label, install the supplies you want to use for printing
the label. You may change supplies during the label composition process,
but you then may have to make length or color adjustments to your label
before you can print it.
The system reads the memory cells on the cartridges every time you open and close
the printer, whether you install new supplies or not, and when you print a label.
To Next Page
Loading...
Need help?
General
