Brother MFC-4820C - Using your MFC with a Macintosh; Setting up your USB-equipped Apple Macintosh G3, G4 or iMac or iBook with Mac OS 8.6-9.2 or Mac OS X 10.1;10.2.1 or greater

USING YOUR MFC WITH A MACINTOSH
®
21 - 1
21
Setting up your USB-equipped Apple
®
Macintosh
®
G3, G4 or iMac
™
or iBook
™
with Mac OS 8.6-9.2 or Mac OS X
10.1/10.2.1 or greater
The features supported by the MFC will depend on the operating
system you are using. The chart below shows which features are
supported.
*1 You need to download USB Mass Storage Support 1.3.5 from
Apple
®
Web site (www.apple.com).
*2 For Mac OS X 10.2 user, please upgrade to Mac OS X 10.2.1 or
greater. (The latest information for Mac OS X, please visit at:
http://solutions.brother.com)
Using your MFC with a
Macintosh
®
Before you can connect the MFC to your Macintosh
®
, you must
buy a USB cable that is not longer 1.8 metres.
Do not connect the MFC to a USB port on a key board or a
non-powered USB hub.
Feature MAC OS MAC OS X
8.6 9.X 10.1 10.2.1 or
greater*
2
Printing Yes Yes Yes Yes
Scanning (TWAIN) Yes Yes No Yes
PC-FAX sending Yes Yes Yes Yes
Remote Setup No No Yes Yes
PhotoCapture Center
*
1
Yes Yes Yes