23 - 10 TROUBLESHOOTING AND ROUTINE MAINTENANCE
Printing is slow. In the ‘Colour’ tab from the ‘Advanced’ tab in the printer driver, uncheck
the Colour Enhancement.
Colour Enhancement is not
working correctly.
If the image data is not full colour in your application (Such as 256
colour), Colour Enhancement will not work. Please use at least 24 bit
colour data with the Colour Enhancement feature.
‘MFC is Busy’ or ‘MFC
Connect Failure’ Error
Message appears.
Make sure the MFC is not showing an error message on the LCD.
‘MFC Connect Failure’ If the MFC is not connected to your PC and you have loaded the Brother
software, the PC will show ‘MFC Connect Failure’ each time you restart
Windows
®
. You can ignore this message or you can turn it off by
deselecting the
AutoLoad PopUp
check box in the Brother Control
Center chapter. (See How to turn off AutoLoad on page 16-2.)
PhotoCapture Center
™
Difficulties
Removable Disk does not
work properly.
a)Have you installed the Windows
®
2000 update?
If not, do the following:
1. Disconnect the USB cable.
2. Install the Windows 2000
®
update. Please see the Quick Setup
Guide. After the installation the PC will be automatically restarted.
3. Wait about 1 minute after you reboot the PC, and then connect the
USB cable.
b)Take out the media card and put it back in again.
c) If you have tried "Eject", you must take out the media card before you
continue.
d)If an error message appears when you try to eject the media card, it
means the card is being accessed.
Wait a while and then try again.
e)If all of the above do not work, please turn off your PC and MFC, and
then turn them on again.
(You will have to unplug the power cord of the MFC to turn it off.)
DIFFICULTY SUGGESTIONS
To Next Page
Loading...
Need help?
General
