Power distribution and control system
no secure connection.
1. Turn the key switch to the "LOCK" position
and disconnect the negative battery cable.
2. Unscrew the fixing bolts of the high voltage
wire protection plate-as shown by the arrow-,
and remove the high voltage wire protection
plate.
3. Disconnect the power battery high voltage
wire connection plug-as shown by the arrow-.
4. Unscrew the fixing screw - as shown by
the arrow - and remove the upper cover
plate of the PDU- 1 -.
△!
Caution
During installation, it is necessary to
confirm that the sealing strip on the upper
cover plate of the PDU is correctly installed.
To Next Page