Cessna 182 1978 - Page 108

MODEL
182 & T182 SERIES
SERVICE MANUAL
CESSNA PROGRESSIVE
CARE
MODEL
182
& T182
OPERATION
NO.
4
MECHANIC INSPECTOR REMARKS
WINGS
1. Wing
Surfaces
and Tips
- Inspect for
skin damage,
loose
rivets, and
condition of paint.
2.
Placards and
Decals
- Inspect presence,
legibility,
and security.
Consult
Pilot's Operating
Handbook
and FAA-Approved
Airplane Manual
for
required
placards.
3. Wing
Access
Plates - Check
for damage
and security
of installation.
4. Wing
Struts
and
Strut
Fairings
- Check
for dents,
cracks, loose
screws
and rivets,
and condition
of
paint.
5. Wing
Spar and
Wing Strut
Fittings
- Check for
evi-
dence of
wear. Check
attach
bolts for indications
of
looseness
and retorque as
required.
6.
Fuel Tank
or Bladder Drains
- Drain
water and
sedi-
ment.
7. Pitot
Tube
and Stall
Warning
Vane
- Check
for con-
dition
and obstructions.
8.
Pitot
Tube
Heater
Element
(if
installed)
-
Perform
operational check.
9. Fuel
Tank
Vent Lines
and
Vent Valves
- Check
vents
for obstruction
and
proper
positioning.
Check valves
for
operation.
10. Aileron
Structure,
Control
Rods,
Hinges,
Balance
Weights,
Bellcranks,
Linkage,
Bolts,
Pulleys,
and
Pulley
Brackets
- Check
condition,
operation,
and
se-
curity
of attachment.
11.
Ailerons
and Hinges
-
Check condition,
security,
and
operation.
12.
Ailerons and
Cables -
Check operation
and security
of stops.
Check
cables for
tension, routing,
fraying,
corrosion,
and
turnbuckle
safety.
Check
travel
if
cable
tension
requires
adjustment
or
if stops
are
damaged.
Check fairleads
and rub
strips
for condi-
tion.
Sheet
10 of
14
2-76 Revision 1