Cessna 182 1978 - Page 79

MODEL 182 & T182
SERIES SERVICE
MANUAL
CESSNA
PROGRESSIVE
CARE
MODEL 182 & T182
OPERATION
NO.
1
Registration
No.
Airplane Model
and SN
Airplane
Time
INSPECTION
COMPLETED
BY
J
28 Hoses.
Metal Lines.
and Fittings
- Inspect for signs
of oil
and fuel leaks
Check
for abrasions,
chafing.
security.
proper routing
and support and
for evidence of
deterioration
J
29 Cold
and Hot
Air Hoses
- Check
condition,
routing,
and
security
J 30
Engine Cylinders.
Rocker
Box Covers,
and Pushrod
Housings
- Check
for
fin damage,
cracks,
oil
leakage.
security of attachment.
and general
condition.
J
31 Turbocharger
(if applicable)
-
a.
Inspect turbocharger
mounting
bracket, ducting.
linkage, and
attaching parts for general
condition, leakage
or damage.
and security of
attachment.
b. Check
waste gate, actuator, controller.
oil and vent
lines.
overboost relief valve,
and compressor housing
for
leakage,
apparent damage,
security
of attachment,
and
evidence
of wear.
Check waste
gate return
spring
for
condition
and
security.
J
32 Turbocharger
(if applicable)
-
a. Remove
heat shields
and inspect
for burned
areas.
bulges
or cracks.
Remove
tailpipe and
ducting - inspect
turbine
for coking. carbonization.
oil deposits, and
turbine
impellers
for
damage.
J 33 Engine Baffles
and Seals - Check condition
and security of
attachment
J 34
Engine Oil Change
-
Short Oil Filter (approximately
4.8
inches)
a. Replace Filter.
b Add
recommended grade aviation
oil to replace oil lost
in existing filter
Without Oil Filter
- Drain oil sump and oil
cooler, inspect
and clean screens. and
refill with recommended
grade
aviation oil.
J 35 Long
Oil Filter (approximately 5.8
inches) - Drain oil sump
and
oil cooler, replace
filter element. refill
with
recommended grade aviation oil.
J 36
Crankcase,
Oil Sump.
and
Accessory
Section
- Inspect
for
cracks
and evidence
of oil
leakage. Check
bolts and
nuts
for looseness
and
retorque as
necessary. Check
crankcase
breather
lines for obstructions.
security. and general
condition
K
1 Integral
Fuel Tanks
- Check
for evidence
of
leakage
and
condition
of fuel caps.
adapters and placards
K
2 Fuel Bladders
- Check
for leaks and
security, condition
of
fuel
caps. adapters,
and placards.
K
3 Fuel System
- Inspect
plumbing and
components
for
mounting and security
K
4 Fuel
Tank or
Bladder
Drains - Drain
water
and sediment
K 5 Fuel
Tank Vent Lines
and Vent
Valves - Check
vents for
obstruction
and proper
positioning
Check
valves for
operation
K
7 Fuel
Strainer.
Drain
Valve, and
Controls
- Check freedom
of
movement
security, and proper
operation. Disassemble
flush.
and clean screen
and bowl
2-46
Revision
3