Usage Guidelines
Use the dynamic-template type ppp command to enter the ppp dynamic template type configuration mode.
Task ID
OperationTask ID
read, writeppp
read, writeaaa
Examples
This is an example of configuring the ppp ipcp command in the dynamic template configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp p1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# ppp ipcp
Related Commands
DescriptionCommand
Sets PPP link authentication method.ppp authentication (BNG), on page 378
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
384
BNG PPP Commands
ppp ipcp