ppp lcp
To enable the link control protocol (LCP) on PPP interfaces, use the ppp lcp command in the dynamic template
configuration mode. To disable this feature, use the no form of this command.
ppp lcp [ delay delay_seconds delay_milliseconds | renegotiation ignore ]
no ppp lcp
Syntax Description
Sets the time to delay before starting active LCP negotiations.delay
Specifies the delay time in seconds. The value ranges from 0-255.
delay_seconds
Specifies the delay time in milliseconds. The value ranges from 0-999.
delay_milliseconds
Specifies the peer renegotiation options.renegotiation
Specifies the number of attempts that can be ignored by the peer to
renegotiate LCP.
ignore
Command Default
None
Command Modes
Dynamic template configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
Use the dynamic-template type ppp command to enter the ppp dynamic template type configuration mode.
Task ID
OperationTask ID
read, writeppp
read, writeaaa
Examples
This is an example of configuring the ppp lcp command in the dynamic template configuration mode:
RP/0/RSP0/CPU0:router# configure
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
385
BNG PPP Commands
ppp lcp
To Next Page
Loading...
Need help?
General
