Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
Task ID
OperationTask ID
readppp
Examples
This is a sample output of the show pppoe limits command:
RP/0/RSP0/CPU0:router# show pppoe limits active access-interfaces loopback 45
BBA-Group TEST
--------------
Card session limit information:
Maximum session limit: 50 sessions
Warning threshold: 40 sessions
State #Sessions
----- ---------
Block 50
Access-interface session limits not configured.
MAC session limits not configured.
MAC-IWF session limits not configured.
Circuit-ID session limit information:
Maximum session limit: 50 sessions
Warning threshold: 40 sessions
Circuit-ID State #Sessions
---------- ----- ---------
circuit_id1 Block 50
circuit_id_field_which_can_be_up_to_sixty_four_chars_long Warn 45
circuit_id2 OK 32
circuit_id,/[]* OK 1
BBA-Group TEST2
---------------
Card session limits not configured.
Access-interfaces session limit information:
Maximum session limit: 50 sessions
Warning threshold: 40 sessions
Access-Interface State #Sessions
---------------- ----- ---------
GE0/1/0/0/0 Block 50
GE0/1/0/0/1 Warn 45
GE0/1/0/0/2 OK 32
GE0/1/0/0/0.12 OK 1
MAC session limits not configured.
MAC-IWF session limits not configured.
Circuit-ID session limits not configured.
This is another sample output of show pppoe limits command:
RP/0/RSP0/CPU0:router# show pppoe limits
Tue Feb 5 21:09:40.823 UTC
0/RSP1/CPU0
-----------
BBA-Group BNG_BBA
-----------------
Card session limits not configured.
Access-interface session limits not configured.
MAC session limits not configured.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
467
PPPoE Commands
show pppoe limits
To Next Page
Loading...
Need help?
General
