MAC-IWF session limits not configured.
Circuit-ID session limit information:
Maximum session limit: 10 sessions
Warning threshold: 8 sessions
Circuit-ID State #Sessions
---------- ----- ---------
circuit0 Block 10
Remote-ID session limit information:
Maximum session limit: 10 sessions
Warning threshold: 8 sessions
Remote-ID State #Sessions
---------- ----- ---------
remote10 Block 10
MAC-Access-Interface session limits not configured.
MAC-IWF-Access-Interface session limits not configured.
Inner-VLAN-ID session limit information:
Maximum session limit: 10 sessions
Warning threshold: 8 sessions
Access-Int Inner VLAN ID State #Sessions
---------- ------------- ----- ---------
BE2.10 10 Block 10
Outer-VLAN-ID session limit information:
Maximum session limit: 10 sessions
Warning threshold: 8 sessions
Access-Int Outer VLAN ID State #Sessions
---------- ------------- ----- ---------
BE2.10 10 Block 10
VLAN-ID session limit information:
Maximum session limit: 10 sessions
Warning threshold: 8 sessions
Access-Int Outer, Inner VLAN ID State #Sessions
---------- -------------------- ----- ---------
BE2.10 10, 10 Block 10
Circuit-ID-and-Remote-ID session limit information:
Maximum session limit: 10 sessions
Warning threshold: 8 sessions
Circuit-ID State #Sessions
Remote-ID (/Max)
----------- ----- ---------
circuit0 Block 10
remote10
This table describes the significant fields displayed in the show pppoe limits command output :
DescriptionField
Specifies that the number of sessions is at the
maximum limit.
Block
Specifies that the number of sessions is below the
maximum limit and the warning threshold (if
configured).
OK
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
468
PPPoE Commands
show pppoe limits
To Next Page
Loading...
Need help?
General
