Circuit-ID throttle information:
Max packets per request period: 10
Request period duration: 10s
Blocking period duration: 100s
Time Since
Circuit-ID State left reset PADI PADR
---------- ----- ---- ----- ---- ----
circuit0 Block 91s 8s 10 10
Remote-ID throttle information:
Max packets per request period: 10
Request period duration: 10s
Blocking period duration: 100s
Time Since
Remote-ID State left reset PADI PADR
---------- ----- ---- ----- ---- ----
remote10 Block 91s 8s 10 10
Inner-VLAN-ID throttle information:
Max packets per request period: 10
Request period duration: 10s
Blocking period duration: 100s
Time Since
Access-Int Inner VLAN ID State left reset PADI PADR
---------- ------------- ----- ---- ----- ---- ----
BE2.10 10 Block 91s 8s 10 10
Outer-VLAN-ID throttle information:
Max packets per request period: 10
Request period duration: 10s
Blocking period duration: 100s
Time Since
Access-Int Outer VLAN ID State left reset PADI PADR
---------- ------------- ----- ---- ----- ---- ----
BE2.10 10 Block 91s 8s 10 10
VLAN-ID throttle information:
Max packets per request period: 10
Request period duration: 10s
Blocking period duration: 100s
Time Since
Access-Int Outer, Inner VLAN ID State left reset PADI PADR
---------- -------------------- ----- ---- ----- ---- ----
BE2.10 10, 10 Block 91s 8s 10 10
Circuit-ID-and-Remote-ID throttle information:
Max packets per request period: 0
Request period duration: 0s
Blocking period duration: 0s
Time Since
Circuit-ID State left reset PADI PADR
Remote-ID
----------- ----- ---- ----- ---- ----
circuit0 Block 91s 8s 10 10
remote10
This table describes the significant fields displayed in the show pppoe throttles command output :
DescriptionField
Specifies that the throttle is active and that packets
are dropped.
Block
Specifies that the packets relevant to the throttle are
not yet received.
Idle
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
477
PPPoE Commands
show pppoe throttles