DescriptionField
Specifies that the packets are counted, but the throttle
is not yet active.
Monitor
Specifies the time remaining until the throttle enters
idle state, or if the throttle is already in idle state, the
time until the throttle entry is removed.
Time left
Specifies the time since the throttle counters were last
reset. Throttle counters are reset upon entering the
idle state.
Since reset
Specifies the number of PADI messages received
which match the entry criteria (say, mac address).
PADI
Specifies the number of PADR messages received
which match the entry criteria (say, mac address).
PADR
Related Commands
DescriptionCommand
Configures a throttle value for PPPoE sessions for a PPPoE
BBA-Group in BNG.
pppoe sessions throttle, on page 460
Shows the PPPoE session limit information.show pppoe limits, on page 466
Shows a summary of the protocol state for the specified PPPoE
interface filtered by circuit-id, remote-id, interface, or location.
show pppoe interfaces, on page 464
Shows the counters for packets received and sent by the PPPoE
sessions.
show pppoe statistics, on page 470
Shows summary information of the PPPoE sessions.show pppoe summary, on page 473
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
478
PPPoE Commands
show pppoe throttles
To Next Page
Loading...
Need help?
General
