Cisco ASR 920 series Configuration Guide Ethernet Router

PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Specifies the interface type and number, and enters interface
configuration mode.
interface type number
Example:
Device(config)# interface gigabitethernet2/0/1
Step 3
Creates a service instance on an interface and enters service
instance configuration mode.
service instance id ethernet
Example:
Device(config-if)# service instance 100
ethernet
Step 4
Defines the matching criteria to be used in order to map
ingress dot1q frames on an interface to the appropriate
service instance.
encapsulation dot1q vlan-id
Example:
Device(config-if-srv)# encapsulation dot1q 100
Step 5
Binds the service instance to a bridge- domain instance
where bridge-id is the identifier for the bridge- domain
instance.
bridge-domain bridge-id
Example:
Device(config-if-srv)# bridge-domain 200
Step 6
Enables MAC security on the service instance.mac security
Example:
Device(config-if-srv)# mac security
Step 7
Returns to user EXEC mode.end
Example:
Device(config-if-srv)# end
Step 8
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
91
Configuring MAC Address Limiting on Service Instances Bridge Domains and EVC Port Channels
Enabling MAC Security on a Service Instance

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English