Cisco ASR 920 series Configuration Guide Ethernet Router

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id
4.
service {ma-name | ma-num | vlan-id vlan-id | vpn-id vpn-id} [port | vlan vlan-id [direction down]]
5.
continuity-check [interval time | loss-threshold threshold | static rmep]
6.
continuity-check [interval time | loss-threshold threshold | static rmep]
7.
continuity-check [interval time | loss-threshold threshold | static rmep]
8.
exit
9.
mep archive-hold-time minutes
10.
exit
11.
ethernet cfm global
12.
ethernet cfm ieee
13.
ethernet cfm traceroute cache
14.
ethernet cfm traceroute cache size entries
15.
ethernet cfm traceroute cache hold-time minutes
16.
interface slot/subslot/port
17.
ethernet cfm mep domain domain-name mpid mpid {port | vlan vlan-id}
18.
ethernet cfm mep domain domain-name mpid mpid {port | vlan vlan-id}
19.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Router> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Defines a CFM maintenance domain at a specified
maintenance level and enters Ethernet CFM configuration
mode.
ethernet cfm domain domain-name level level-id
Example:
Router(config)# ethernet cfm domain Customer
level 7
Step 3
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
261
Configuring Ethernet CFM
Configuring Ethernet CFM

Cisco ASR 920 series Specifications

General

Form Factor	1RU
Operating System	Cisco IOS XE
Model	ASR 920 series
Memory	4 GB DRAM
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
MTBF	Varies by model
Management	CLI, SNMP