Cisco ASR 920 series

PurposeCommand or Action
Sets the amount of time that CFM traceroute cache entries
are retained.
ethernet cfm traceroute cache hold-time minutes
Example:
Device(config)# ethernet cfm traceroute cache
hold-time 60
Step 15
Specifies an interface and enters interface configuration
mode.
interface slot/subslot/port
Example:
Device(config)# interface gigabitethernet 0/0/3
Step 16
Provisions an interface as a domain boundary.
ethernet cfm mep level level-id [inward | outward
domain domain-name] mpid id vlan {any | vlan-id | ,
vlan-id | vlan-id - vlan-id | , vlan-id - vlan-id}
Step 17
Example:
Device(config-if)# ethernet cfm mep level 7
outward domain Customer mpid 701 vlan 100
Returns the device to privileged EXEC mode.end
Example:
Device(config-if)# end
Step 18
Example:
Device#
Configuring and Enabling the Cross-Check Function (CE-A)
Perform this task to configure and enable cross-checking for a down MEP. This task requires you to configure
and enable cross-checking on two devices. This task is optional.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
267
Configuring Ethernet CFM
Configuring Ethernet CFM