Cisco ASR 920 series Configuration Guide Ethernet Router

PurposeCommand or Action
Sets a port as internal to a maintenance domain and defines
it as a MEP.
ethernet cfm mep domain domain-name mpid
mpid {port | vlan vlan-id}
Example:
Router(config-if)# ethernet cfm mep domain
Customer mpid 701 vlan 100
Step 18
Returns the device to privileged EXEC mode.end
Example:
Router(config-if)# end
Step 19
Provisioning Service (CE-B)
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id [direction outward]
4.
mep archive-hold-time minutes
5.
service {ma-name | ma-num| evc evc-name|vlan-id vlan-id | vpn-id vpn-id} [port | vlan vlan-id [direction
down]]
6.
continuity-check [interval time | loss-threshold threshold | static rmep]
7.
continuity-check [interval time | loss-threshold threshold | static rmep]
8.
continuity-check [interval time | loss-threshold threshold | static rmep]
9.
exit
10.
exit
11.
ethernet cfm global
12.
ethernet cfm ieee
13.
ethernet cfm traceroute cache
14.
ethernet cfm traceroute cache size entries
15.
ethernet cfm traceroute cache hold-time minutes
16.
interface slot/subslot/port
17.
ethernet cfm mep level level-id [inward | outward domain domain-name] mpid id vlan {any | vlan-id
| , vlan-id | vlan-id - vlan-id | , vlan-id - vlan-id}
18.
end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
264
Configuring Ethernet CFM
Configuring Ethernet CFM

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English