PE3(config-if)# service instance 256 ethernet 256
PE3(config-if-srv)# encapsulation dot1q 256
PE3(config-if-srv)# xconnect 1.1.1.1 1 encapsulation mpls
PE3(cfg-if-ether-vc-xconn)# cfm mep domain L6 mpid 256
PE3(config-if-srv-ecfm-mep)# end
Verifiying CFM over EFP
•
Use the show ethernet cfm ma remote commands to verify the CFM over EVC configuration. This
command shows the basic configuration information for CFM.
Router-30-PE1# show ethernet cfm ma local
Local MEPs:
--------------------------------------------------------------------------------
MPID Domain Name Lvl MacAddress Type CC
Domain Id Dir Port Id
MA Name SrvcInst
EVC name
--------------------------------------------------------------------------------
1 L6 6 000a.f393.56d0 XCON Y
L6 Down Te2/0/0 N/A
bbb 1
bbb
3 L5 5 0007.8478.4410 XCON Y
L5 Up Te2/0/0 N/A
bbb 1
bbb
Total Local MEPs: 2
Local MIPs:
* = MIP Manually Configured
--------------------------------------------------------------------------------
Level Port MacAddress SrvcInst Type Id
--------------------------------------------------------------------------------
7 Te2/0/0 0007.8478.4410 1 XCON N/A
Total Local MIPs: 1
•
Use the show ethernet cfm ma remote to verify the MEP configuration:
Router-30-PE1# show ethernet cfm ma remote
--------------------------------------------------------------------------------
MPID Domain Name MacAddress IfSt PtSt
Lvl Domain ID Ingress
RDI MA Name Type Id SrvcInst
EVC Name Age
--------------------------------------------------------------------------------
4 L5 000a.f393.56d0 Up Up
5 L5 Te2/0/0:(2.2.2.2, 1)
- bbb XCON N/A 1
bbb 9s
2 L6 000a.f393.56d0 Up Up
6 L6 Te2/0/0:(2.2.2.2, 1)
- bbb XCON N/A 1
bbb 1s
Total Remote MEPs: 2
•
Use the show ethernet cfm mpdb command to verify the catalouge of CC with MIP in intermediate
routers.
PE2# show ethernet cfm mpdb
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
227
CFM Configuration over EFP Interface with Cross Connect Feature
Verifiying CFM over EFP