EasyManuals Logo

Cisco ASR 920 series Configuration Guide Ethernet Router

Cisco ASR 920 series
438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #314 background imageLoading...
Page #314 background image
Examples
The following example shows sample output from the show ethernet lmi command using the evc keyword:
Device# show ethernet lmi evc
St EVC Id Port
--- ------------------------------------------------------------ --------------
A EVC_MP2MP_101 Gi0/1
A EVC_P2P_110 Gi0/1
The following example is sample output from the show ethernet service evc command:
Device# show ethernet service evc
Identifier Type Act-UNI-cnt Status
50 MP-MP 0 NotDefined
The following is sample output from the show ethernet service interface command using the detail keyword:
Device# show ethernet service interface gigabitethernet 0/0/2 detail
Interface: Gigabitethernet 0/0/2
ID: uni2
CE-VLANS: 30
EVC Map Type: Bundling
Associated EVCs:
EVC-ID CE-VLAN
50 30
Associated Service Instances:
Service-Instance-ID CE-VLAN
400 30
The following is sample output from the show ethernet service instance command using the detail keyword:
Device# show ethernet service instance detail
Service Instance ID: 400
Associated Interface: GigabitEthernet0/0/2
Associated EVC: 50
CE-Vlans: 30
State: AdminDown
EFP Statistics:
Pkts In Bytes In Pkts Out Bytes Out
0 0 0 0
Configuration Examples for Ethernet Local Management
Interface at a Provider Edge
Example: Ethernet OAM Manager on a PE Device Configuration
This example shows a sample configuration of Operation, Administration, and Management (OAM) manager,
Connectivity Fault Management (CFM), and Ethernet Local Management Interface (LMI) on a provider edge
(PE) device. In this example, a bridge domain is specified.
Device> enable
Device# configure terminal
Device(config)# ethernet cfm global
Device(config)# ethernet cfm domain provider level 4
Device(config-ecfm)# service customer_1 evc test1 vlan 10
Device(config-ecfm-srv)# continuity-check
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
296
Configuring Ethernet Local Management Interface at a Provider Edge
Configuration Examples for Ethernet Local Management Interface at a Provider Edge

Table of Contents

Other manuals for Cisco ASR 920 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 920 series and is the answer not in the manual?

Cisco ASR 920 series Specifications

General IconGeneral
Form Factor1RU
Operating SystemCisco IOS XE
ModelASR 920 series
Memory4 GB DRAM
Power SupplyAC or DC
Storage Temperature-40°C to 70°C (-40°F to 158°F)
Relative Humidity5% to 95% non-condensing
MTBFVaries by model
ManagementCLI, SNMP

Related product manuals