Cisco ASR 920 series

PurposeCommand or Action
Example:
Device(config-if)# channel-group 5 mode active
•
In this instance, the interface from Step 3 is added.
Removes the Gigabit Ethernet interface from channel
group.
no channel-group channel-group-number
Example:
Device(config-if)# no channel-group 5
Step 5
Returns to privileged EXEC mode.end
Example:
Device(config-if)# end
Step 6
Removing a Channel Group from a Port
Perform this task to remove a Gigabit Ethernet port channel group from a physical port.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
no interface port-channel number
4.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Removes the specified port channel group from a physical
port.
no interface port-channel number
Example:
Device(config)# no interface port-channel 1
Step 3
• number—Valid range is from 1 to 64.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
367
Configuring IEEE 802.3ad Link Bundling
Removing a Channel Group from a Port