Cisco ASR 920 series

Provisioning Service on the PE-AGG A
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id
4.
service short-ma-name evc evc-name vlan vlanid direction down
5.
continuity-check
6.
continuity-check [interval cc-interval]
7.
exit
8.
mep archive-hold-time minutes
9.
exit
10.
ethernet cfm global
11.
interface type number
12.
service instance id ethernet [evc-name]
13.
encapsulation encapsulation-type
14.
bridge-domain bridge-id
15.
cfm mip level level
16.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Defines a CFM maintenance domain at a particular
maintenance level and enters Ethernet CFM configuration
mode.
ethernet cfm domain domain-name level level-id
Example:
Device(config)# ethernet cfm domain Customer
level 7
Step 3
Configures a maintenance association within a maintenance
domain and enters Ethernet connectivity fault management
(CFM) service configuration mode.
service short-ma-name evc evc-name vlan vlanid
direction down
Example:
Device(config-ecfm)# service s41 evc 41 vlan
41 direction down
Step 4
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
170
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Configuring Ethernet CFM