Cisco ASR 920 series

PurposeCommand or Action
Enables Ethernet OAM.
ethernet oam [max-rate oampdus | min-rate num-seconds|
mode {active | passive} | timeout seconds]
Step 4
Example:
Device(config-if)# ethernet oam
Returns to global configuration mode.exit
Example:
Device(config-if)# exit
Step 5
Disabling and Enabling a Link Monitoring Session
Link monitoring is enabled by default when you enable Ethernet OAM. Perform these tasks to disable and
enable link monitoring sessions:
Disabling a Link Monitoring Session
Perform this task to disable a link monitoring session.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface type number
4.
ethernet oam [max-rate oampdus | min-rate num-seconds| mode {active | passive} | timeout seconds]
5.
no ethernet oam link-monitor supported
6.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
305
Using Ethernet Operations Administration and Maintenance
Disabling and Enabling a Link Monitoring Session