Cisco ASR 920 series Configuration Guide Ethernet Router

DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Specifies the interface type and number and enters interface
configuration mode.
interface type number
Example:
Device(config)# interface Gigabitethernet
0/1
Step 3
Disables an LLDP-MED TLV or LLDP packet reception on
a supported interface.
To enable LLDP on a Supported Interface, use the
lldp {med-tlv-select tlv | receive | transmit
command.
Note
no lldp {med-tlv-select tlv | receive | transmit}
Example:
Device(config-if)# no lldp receive
Step 4
Returns to privileged EXEC mode.end
Example:
Device(config-if)# end
Step 5
Enabling LLDP on a Supported Interface
LLDP information can be transmitted and received only on an interface where LLDP is configured and enabled.
Perform this task to enable LLDP.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface type number
4.
lldp {med-tlv-select tlv | receive | transmit}
5.
end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
335
Using Link Layer Discovery Protocol in Multivendor Networks
Disabling and Enabling LLDP on a Supported Interface

Cisco ASR 920 series Specifications

General

Form Factor	1RU
Operating System	Cisco IOS XE
Model	ASR 920 series
Memory	4 GB DRAM
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
MTBF	Varies by model
Management	CLI, SNMP