Cisco ASR 920 series

Provisioning the Network on the N-PE A
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id
4.
service short-ma-name evc evc-name vlan vlanid direction down
5.
continuity-check
6.
continuity-check [interval cc-interval]
7.
exit
8.
ethernet cfm global
9.
ethernet cfm traceroute cache
10.
ethernet cfm traceroute cache size entries
11.
ethernet cfm traceroute cache hold-time minutes
12.
interface type number
13.
service instance id ethernet [evc-name]
14.
encapsulation encapsulation-type
15.
bridge-domain bridge-id
16.
cfm mip level level
17.
exit
18.
exit
19.
snmp-server enable traps ethernet cfm cc [mep-up] [mep-down] [config] [loop] [cross-connect]
20.
snmp-server enable traps ethernet cfm crosscheck [mep-unknown | mep-missing | service-up]
21.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
147
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Configuring Ethernet CFM