Cisco ASR 920 series Configuration Guide Ethernet Router

* = Can Ping/Traceroute to MEP
--------------------------------------------------------------------------------
MPID Domain Name MacAddress Version
Lvl Domain ID Ingress
Expd MA Name Type Id SrvcInst
EVC Name Age
--------------------------------------------------------------------------------
600 * L6 0021.d8ca.d7d0 IEEE-CFM
6 L6 Te2/1:(2.2.2.2, 1)
- s1 XCON N/A 1
1 2s
700 L7 001f.cab7.fd01 IEEE-CFM
7 L7 Te2/1:(2.2.2.2, 1)
- s1 XCON N/A 1
1 3s
Total Remote MEPs: 2
•
Use the show mpls l2 transport vc 1 detail commaned to show detailed configuration information:
PE1# show mpls l2 vc 1 detail
Local interface: Te8/0/1 up, line protocol up, Eth VLAN 200 up
Interworking type is Ethernet
Destination address: 3.3.3.3, VC ID: 1, VC status: up
Output interface: Te8/0/0, imposed label stack {21}
Preferred path: not configured
Default path: active
Next hop: 20.1.1.2
Create time: 21:13:27, last status change time: 02:55:33
Signaling protocol: LDP, peer 3.3.3.3:0 up
Targeted Hello: 2.2.2.2(LDP Id) -> 3.3.3.3, LDP is UP
Status TLV support (local/remote) : enabled/supported
LDP route watch : enabled
Label/status state machine : established, LruRru
Last local dataplane status rcvd: No fault
Last local SSS circuit status rcvd: No fault
Last local SSS circuit status sent: No fault
Last local LDP TLV status sent: No fault
Last remote LDP TLV status rcvd: No fault
Last remote LDP ADJ status rcvd: No fault
MPLS VC labels: local 21, remote 21
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
Control Word: On (configured: autosense)
VC statistics:
transit packet totals: receive 37, send 1067452272
transit byte totals: receive 4181, send 72586757556
transit packet drops: receive 0, seq error 0, send 0
•
Use show mpls forwarding-table command to verify the cross connect VC:
PE1# show mpls forwarding-table
Local Outgoing Prefix Bytes Label Outgoing Next Hop
Label Label or Tunnel Id Switched interface
17 Pop Label 3.3.3.3/32 23038746624 Te8/0/0 20.1.1.2
21 No Label l2ckt(1) 4181 Te8/0/1 point2point
•
Use show ethernet cfm error command to view the error report:
PE2# show ethernet cfm error
--------------------------------------------------------------------------------
MPID Domain Id Mac Address Type Id Lvl
MAName Reason Age
--------------------------------------------------------------------------------
- L3 001d.45fe.ca81 BD-V 200 3
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
228
CFM Configuration over EFP Interface with Cross Connect Feature
Verifiying CFM over EFP

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English