Cisco ASR 920 series

Starting Link Monitoring Operations
Perform this task to start link monitoring operations.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface type number
4.
ethernet oam link-monitor on
5.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Specifies an interface and enters interface
configuration mode.
interface type number
Example:
Device(config)# interface gigabitethernet 0/0/2
Step 3
Starts link monitoring operations.ethernet oam link-monitor on
Example:
Device(config-if)# ethernet oam link-monitor on
Step 4
Returns to global configuration mode.exit
Example:
Device(config-if)# exit
Step 5
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
309
Using Ethernet Operations Administration and Maintenance
Stopping and Starting Link Monitoring Operations