Cisco ASR 920 series

PurposeCommand or Action
Sets the amount of time that CFM traceroute cache entries
are retained.
ethernet cfm traceroute cache hold-time minutes
Example:
Device(config)# ethernet cfm traceroute cache
hold-time 60
Step 10
Enables SNMP trap generation for Ethernet CFM mep-up,
mep-down, config, loop, and cross-connect events.
snmp-server enable traps ethernet cfm cc [mep-up]
[mep-down] [config] [loop] [cross-connect]
Example:
Device(config)# snmp-server enable traps ethernet
Step 11
cfm cc mep-up mep-down config loop cross-connect
Enables SNMP trap generation for Ethernet CFM
mep-unknown, mep-missing, and service-up continuity
snmp-server enable traps ethernet cfm crosscheck
[mep-unknown] [mep-missing] [service-up]
Step 12
check events in relation to the cross-check operation
Example:
Device(config)# snmp-server enable traps ethernet
cfm crosscheck mep-unknown
between statically configured MEPs and those learned via
CCMs.
Returns the device to privileged EXEC mode.end
Example:
Device(config)# end
Step 13
Example:
Provisioning Service (CE-A)
Perform this task to set up service for Ethernet CFM. Optionally, when this task is completed, you may
configure and enable the cross-check function. To perform this optional task, see Configuring and Enabling
the Cross-Check Function (CE-A), on page 267.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
260
Configuring Ethernet CFM
Configuring Ethernet CFM