Cisco ASR 920 series

DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Disables LLDP globally.no lldp run
Example:
Device(config)# no lldp run
Step 3
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 4
Disabling and Enabling LLDP on a Supported Interface
LLDP is enabled by default on all supported interfaces. This section describes the tasks for disabling and
enabling LLDP on a supported interface.
Disabling LLDP on a Supported Interface
Perform this task to disable LLDP on a supported interface.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface type number
4.
no lldp {med-tlv-select tlv | receive | transmit}
5.
end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
334
Using Link Layer Discovery Protocol in Multivendor Networks
Disabling and Enabling LLDP on a Supported Interface