Cisco ASR 920 series Configuration Guide Ethernet Router

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface type number
4.
lldp med-tlv-select tlv
5.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Specifies the interface type and number on which to enable
LLDP-MED and enters interface configuration mode.
interface type number
Example:
Device(config)# interface Gigabitethernet
0/1
Step 3
Enables a specific LLDP-MED TLV on a supported interface.
To disable LLDP-MED TLVs, use the no lldp
med-tlv-select tlv command.
Note
lldp med-tlv-select tlv
Example:
Device(config-if)# lldp med-tlv-select
inventory-management
Step 4
Returns to privileged EXEC mode.end
Example:
Device(config-if)# end
Step 5
Disabling LLDP-MED TLVs
Perform this task to disable a specific LLDP-MED TLV from a supported interface.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
342
Using Link Layer Discovery Protocol in Multivendor Networks
Enabling and Disabling LLDP-MED TLVs

Cisco ASR 920 series Specifications

General

Form Factor	1RU
Operating System	Cisco IOS XE
Model	ASR 920 series
Memory	4 GB DRAM
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
MTBF	Varies by model
Management	CLI, SNMP