Cisco ASR 920 series Configuration Guide Ethernet Router

PurposeCommand or Action
Returns the device to global configuration mode.exit
Example:
Router(config-ecfm)# exit
Step 10
Enables CFM processing globally on the device.ethernet cfm global
Example:
Router(config)# ethernet cfm global
Step 11
Enables the CFM IEEE version of CFM.ethernet cfm ieee
Step 12
Example:
Router(config)# ethernet cfm ieee
•
This command is automatically issued when the
ethernet cfm global command is issued.
Enables caching of CFM data learned through traceroute
messages.
ethernet cfm traceroute cache
Example:
Router(config)# ethernet cfm traceroute cache
Step 13
Sets the maximum size for the CFM traceroute cache table.
ethernet cfm traceroute cache size entries
Example:
Router(config)# ethernet cfm traceroute cache
size 200
Step 14
Sets the amount of time that CFM traceroute cache entries
are retained.
ethernet cfm traceroute cache hold-time minutes
Example:
Router(config)# ethernet cfm traceroute cache
hold-time 60
Step 15
Specifies an interface and enters interface configuration
mode.
interface slot/subslot/port
Example:
Router(config)# interface gigabit ethernet 0/0/3
Step 16
Sets a port as internal to a maintenance domain and defines
it as a MEP.
ethernet cfm mep domain domain-name mpid
mpid {port | vlan vlan-id}
Example:
Router(config-if)# ethernet cfm mep domain
Customer mpid 701 vlan 100
Step 17
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
263
Configuring Ethernet CFM
Configuring Ethernet CFM

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English